Detail:
Name:*******
E-mail:fksz23@163.com
Mobie phone:02880763624
Room phone:02882852792
----------------------------------------------------------------------------
Experience:
Aug.1-Aug.10 as a intern I worked in kelai microwave corporation, responsible for designing and building LC filter. My real job was to design a bandpass LC filter with center frequency 140MHZ,bandwidth 50% .After ten days work, I was very familiar with ADS 、HFSS to design filter and have a deep understanding of the real high frequency circuits .At the same time I grasped how to use instrument such as oscilloscope or net analysis and so on to test and debug the real circuits.
And then I take part in a training about MCU and DSP lasting 20 days .During this training I study very hard, because I have had some basic understanding about the real circuits, and also I could get face to face guide from the experienced teachers. so these days I touched a lot of real circuits, such as the power-supply circuits, operation amplify circuits, communication circuits and so on. after that I believe I have had the ability to design my own circuits with MCU and DSP device.
After that I could take part in two projects by chance. That was I can work as a intern in agilent department in qianfeng electronic corporation(this department is established by agilent and qianfeng electronic corporation ) I was responsible for PCBlayout. the two projects, one is video process system based on TI'S multimedia processor DM642,the other is modulation analysis apparatus. My job was to use protel2004 drawing the PCBlayout of the first project. But I didn't satisfied with this arrangement, I had been very familiar with protel and already had the ability to draw multipliers skilledly, I just want to be a system engineer and know the whole job, responsible for all and also I have a strong interest in digital device. so I was determined to be a member of them. and I used much time learning verilog, ISE and other software. But when I can use verilog to code
test bench, they have finished their project, so I left my loved work.
I don't think I will have a bad performance than the master degree student. I believe I can do the technique job, and will have a better performance than them
----------------------------------------------------------------------------
Core course:
Advanced Mathematics, College Physics, College English, Linear Algebra, Theory of Circuitry, Signal & System, Digital Design, Principle of Microcomputer, Basis of Software Technique, Microwave Technique, Principle of Communication, Digital Signal Processing, C language, Automatic Control Theory, Analogical Electronics, Principle of Single-Chip computer, and so on.
-------------------------------------------------------------------------------------------------------
English skill:
Past CET-4,CET-6,can practicedly read technology document, good both speaking and writing English
-------------------------------------------------------------------------------------------------------
Education:
Sept.2003---July 2007 Department of Electronic Engineering BSEE
Feb.2005----July 2007 Department of business administration bachelor degree
-------------------------------------------------------------------------------------------------------
Major skill:
Have a deep understanding about analog, digital, microwave circuits, skilled with protel drawing schematic diagram and PCBlayout.
Familiar with the hardware design of Real-time Operation System, such as linux, winCE,Vxworks, can understand the basic code of linux core analysis ,core tailor, file system, and device driver,familiar with MiniGUI, understand the structural frame of ARM 7,familiar with ARM7 instruct set.
------------------------------------------------------------------------------------------------------
Social Experience:
As a newsman I worked for
www.stuhome.net (one of the biggest student portal site and also is the official network of UESTC’s student work )for about seven month .
As a charge person in network propagate I work for the Student Flat Management Committee for two month, have some ability of organization, coordination,leadship.
